|
|
| (6 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| The only input variable required for this calculation is the following:
| | #redirect [[HY8:Tumbling_Flow#Tumbling_Flow_in_Circular_Culverts]] |
| | |
| * Diameter of enlarged culvert
| |
| | |
|
| |
| | |
| The following figures show implementations of tumbling flow within circular culverts along with the variables used to design the energy dissipator.
| |
| | |
| [[Image:HY8fig7-1.jpg]]
| |
| | |
| Variables from the figure
| |
| | |
| * D -- Diameter of original culvert
| |
| * V<sub>n</sub> -- Tailwater velocity
| |
| * y<sub>n</sub> -- Tailwater depth
| |
| * L -- Length from beginning of one roughness element to the beginning of the next roughness element.
| |
| * h -- Height of roughness element
| |
| * h<sub>1</sub> -- length from top of roughness element to enlarged culvert ceiling
| |
| * h<sub>2</sub> -- height of splash shield on enlarged culvert ceiling.
| |
| * h<sub>3</sub> -- rise of enlarged culvert.
| |
| | |
| [[Image:HY8fig7-4.jpg]]
| |
| | |
| Variables from the figure
| |
| | |
| * D -- Diameter of original culvert
| |
| * D<sub>1</sub> -- Diameter of enlarged culvert
| |
| * D<sub>i</sub> -- Diameter of roughened section
| |
| * h -- Height of roughness element
| |
| * L -- Length from beginning of one roughness element to the beginning of the next roughness element.
| |
|
| |
| [[Image:HY8image6.jpg]] | |
| | |
| Variables from the figure
| |
| | |
| * D -- Diameter of original culvert
| |
| * T -- Water surface width at critical flow condition
| |
| * y -- Depth of flow
| |
| | |
| | |
| | |
| {{HY8Main}}
| |
