|
|
| (2 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| ==CGWAVE Menu==
| | #redirect [[SMS:CGWAVE Graphical Interface#CGWAVE Menu]] |
| The following menu commands are available in the [[SMS:CGWAVE|CGWAVE]] Menu:
| |
| * [[SMS:CGWAVE Boundary Conditions Dialog|'''Assign BC''']]
| |
| <blockquote>
| |
| This command is used to assign boundary conditions along a selected [[SMS:CGWAVE Boundary Conditions Dialog|nodestring(s)]].
| |
| </blockquote>
| |
| *'''Material Properties'''
| |
| <blockquote>
| |
| Material properties can be assigned and defined.
| |
| </blockquote>
| |
| <blockquote>
| |
| *''Bottom friction'' – The bottom friction can be specified for the element(s) and material selected in this field.
| |
| * ''Floating dock'' – Represent an object anchored in place, but floating in or on the water and thereby obstructing wave fields. Elements will be treated as floating barriers when the simulation is saved.
| |
| </blockquote>
| |
| * '''Model Check'''
| |
| <blockquote>
| |
| Check for common problems. The ''model checker'' performs the generic mesh checking along with optionally checking to insure:
| |
| </blockquote>
| |
| <blockquote>
| |
| * that all boundaries mesh boundaries are assigned as land with a reflection coefficient or as open ocean.
| |
| * that all water depths are positive.
| |
| </blockquote>
| |
| * [[SMS:CGWAVE Model Control|'''Model Control''']]
| |
| <blockquote>
| |
| Brings up the ''Model Control'' dialog to specificy model parameters. </blockquote>
| |
| *'''Reset 1D Spacing '''
| |
| <blockquote> ... </blockquote>
| |
| *'''Run CGWAVE '''
| |
| <blockquote>Brings up a dialog that allows the user to check what executable of CGWAVE should be run and then runs the model with the currently loaded simulation. As the model runs, a dialog monitors progress of the model and gives the user status messages. When the run is complete, the spatial solutions are read in for analysis and visualization. </blockquote>
| |
| | |
| ===Obsolete Commands===
| |
| The following commands are no longer in current versions of SMS.
| |
| * [[SMS:Spectral Energy|'''Spectral Energy''']]
| |
| <blockquote>
| |
| Brings up the ''Spectral Energy'' dialog to define/view wave energy spectra. This command also allows the user to visualize wave spectra.
| |
| </blockquote>
| |
