Template:Fill Nodata: Difference between revisions
From XMS Wiki
Jump to navigationJump to search
(Created page with "__NOINDEX__ __NOTOC__ <noinclude>Category:Tools</noinclude>") |
No edit summary |
||
| (8 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
__NOINDEX__ | __NOINDEX__ | ||
__NOTOC__ | __NOTOC__ | ||
===Fill Nodata=== | |||
The ''Fill Nodata'' tool creates a new raster by filling in small areas or gaps in a raster where no elevation data exists. The command will interpolate an elevation to raster cells that are classified as "NODATA". The elevation for a NODATA cell is determined by interpolation based on the search radius specified. The command is intended to correct single isolated raster points or a single row/column, and is not intended to create data for large regions of NODATA cells, especially regions on the border of the raster. | |||
====Input parameters==== | |||
*''Input raster'' – The source raster containing the NODATA values. | |||
*''Maximum distance (in pixels) to interpolate'' – Enter a distance used to search out values to interpolate from, to fill in the NODATA values. The default is 100 pixels. | |||
*''The number of 3x3 average filter smoothing iterations to run'' – Enter the number of smoothing iterations to run after the interpolation has been calculated. The default is 0 runs. | |||
====Output parameters==== | |||
*''Output raster'' – Enter a name for the new raster. | |||
<noinclude>[[Category: | ====Current Location in toolbox==== | ||
*Rasters/Fill Nodata | |||
<noinclude>[[Category:Toolbox Rasters]]</noinclude> | |||
Latest revision as of 19:04, 26 October 2023
Fill Nodata
The Fill Nodata tool creates a new raster by filling in small areas or gaps in a raster where no elevation data exists. The command will interpolate an elevation to raster cells that are classified as "NODATA". The elevation for a NODATA cell is determined by interpolation based on the search radius specified. The command is intended to correct single isolated raster points or a single row/column, and is not intended to create data for large regions of NODATA cells, especially regions on the border of the raster.
Input parameters
- Input raster – The source raster containing the NODATA values.
- Maximum distance (in pixels) to interpolate – Enter a distance used to search out values to interpolate from, to fill in the NODATA values. The default is 100 pixels.
- The number of 3x3 average filter smoothing iterations to run – Enter the number of smoothing iterations to run after the interpolation has been calculated. The default is 0 runs.
Output parameters
- Output raster – Enter a name for the new raster.
Current Location in toolbox
- Rasters/Fill Nodata
