|
|
| (7 intermediate revisions by the same user not shown) |
| Line 1: |
Line 1: |
| [[File:rma4 bc nodestrings.jpg|thumb|270|RMA4 Assign Boundary Conditions dialog]] | | #REDIRECT [[SMS:RMA4 Boundary Conditions]] |
| | |
| Nodestrings can be used as boundary conditions to define constituent concentrations being modeled. Constituent concentrations can be defined as constant or transient using the [[XY Series Editor|XY Series Editor]].
| |
| | |
| RMA4 does not care about the units of the concentration because the output is relative to the initial number you specify. For example, if we specify a concentration of 1,000, the values in the solution will range from 0 to 1,000 as the plume spreads downstream. We can say that the concentration is ppm, ppt, or kg/kg; RMA4 treats all concentrations as relative values.
| |
| | |
| Since a concentration in water is rarely rigidly maintained, a shock factor may be applied to allow fluctuation of the concentration when the flow direction changes. If no shock factor is applied, no matter how much the flow pushes the concentration out of the model, the concentration at the boundary will not change. However, applying a shock factor is like creating a buffer zone outside the model where the constituent can go until the flow begins to carry it back into the model. This provides for a more realistic solution in some cases. Depending on the situation, a different shock factor may be applied from zero for no shock to 1.0 for a gradual change due to a change in flow direction.
| |
