HY8:AOP SS Results Table: Difference between revisions
From XMS Wiki
Jump to navigationJump to search
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
=AOP Stream Simulation, Results Table= | =AOP Stream Simulation, Results Table= | ||
[[Image:AopStreamSimulationResults.jpg]] | [[Image:AopStreamSimulationResults.jpg|800 px]] | ||
The purpose of this dialog is to report to the user most of variables used in the computations to verify that the results and process are reasonable. | The purpose of this dialog is to report to the user most of variables used in the computations to verify that the results and process are reasonable. | ||
| Line 9: | Line 9: | ||
===Shear Calculations=== | ===Shear Calculations=== | ||
The equations used to perform these calculations are available in [ | The equations used to perform these calculations are available in [https://www.fhwa.dot.gov/engineering/hydraulics/pubs/11008/hif11008.pdf HEC-26] Chapter 7. It reports the energy slope used, the D50 of the gradation used, the shear velocity, Reynold's value, and Shield's value for the shear calculations and the resulting shear computations. | ||
===Depth & Velocity Calculations=== | ===Depth & Velocity Calculations=== | ||
| Line 16: | Line 16: | ||
{{HY8Main}} | {{HY8Main}} | ||
[[Category:AOP| | [[Category:AOP|results]] | ||
[[Category:External Links]] | |||
[[Category:HY-8 Dialogs|AOP]] | |||
Latest revision as of 16:43, 28 April 2023
AOP Stream Simulation, Results Table
The purpose of this dialog is to report to the user most of variables used in the computations to verify that the results and process are reasonable.
Results Table
Cross Section Calculations
The normal depth, velocity and shear from each cross-section that was calculated using Manning's Equation.
Shear Calculations
The equations used to perform these calculations are available in HEC-26 Chapter 7. It reports the energy slope used, the D50 of the gradation used, the shear velocity, Reynold's value, and Shield's value for the shear calculations and the resulting shear computations.
Depth & Velocity Calculations
These results are the same as given in the Align and Size Culvert step, and are included on this page for completeness and to make comparison easier.
