User:Jcreer/SMS:Feature Stamping Dialogs

Stamping Coverage Attributes

The Stamping Coverage Attributes dialog will appear when creating a new stamping coverage. It can also be reached by right-clicking on the stamping coverage and selecting the Properties command.

• Underlying Geometry – This section contains options for defining the scatter set used in the stamping process.
  • Use cutoff – On this option allows selecting which scatter set to use as a surface. Available scatter sets can be selected from the data tree once this option is enabled. The scatter set will act as a surface to determine the cut-off for the sloped banks of a stamped feature.
  • Bathymetry Type –
    • "Elevation" – The default option. Defines positive values as going up.
    • "Depth" – Defines positive values as going down.

Stamping Arc Attributes

The Stamping Arc Attributes dialog is reached by double-clicking on an arc created in a stamping coverage. It can also be reached by right-clicking on the selected arc and using the Attributes command.

The following attributes can be set:

• Feature Name – This will be used when SMS creates stamped feature coverages and scatter sets from the stamping coverage.
• Stamping Type – Can be set to either use the channel or the embankment.
  • "Cut Feature" – Will stamp the feature using the channel.
  • "Fill Feature" – Will stamp the feature using the embankment.
• End Cap
• Centerline (CL) Profile
  • Constant → Elevation
  • XY Series → Elevation
  • Plot CS Profile
• Cross Section (CS)
  • Side
  • Maximum Distance from CL
  • Specify Top Width and Single Side Slopes
  • Current CS → All CS
  • Plot Current CS

End Cap

• Type of end cap
  • "Guidebank"
  • "Sloped Abutment"
  • "Wing Walls"
• Angle
• Slope
  • Distance
  • Elevation
• Maximum Distance from CS
• Plot Shape