Template:Fill Nodata: Difference between revisions
From XMS Wiki
Jump to navigationJump to search
| Line 9: | Line 9: | ||
===Output parameters=== | ===Output parameters=== | ||
*''Output raster'' – Enter a name for the new raster. | |||
===Current Location in toolbox=== | ===Current Location in toolbox=== | ||
Rasters/Fill Nodata | Rasters/Fill Nodata | ||
<noinclude>[[Category:Tools]]</noinclude> | <noinclude>[[Category:Tools]]</noinclude> | ||
Revision as of 19:29, 1 December 2021
The Fill Nodata tool creates a new raster by filling in small areas or gaps in a raster where no elevation data exists. The command will interpolate an elevation to raster cells that are classified as “NODATA.” The elevation for a NODATA cell is determined by interpolation based on the search radius specified. The command is intended to correct single isolated raster points or a single row/column, and is not intended to create data for large regions of NODATA cells, especially regions on the border of the raster.
Input parameters
- Input raster – The source raster containing the NODATA values.
- Maximum distance (in pixels) to interpolate – Enter a distance used to search out values to interpolate from, to fill in the NODATA values. The default is 100 pixels.
- The number of 3x3 average filter smoothing iterations to run – Enter the number of smoothing iterations to run after the interpolation has been calculated. The default is 0 runs.
Output parameters
- Output raster – Enter a name for the new raster.
Current Location in toolbox
Rasters/Fill Nodata
