HY8:Tumbling Flow in Circular Culverts: Difference between revisions

Revision as of 20:10, 9 January 2013

The only input variable required for this calculation is the following:

The following figures show implementations of tumbling flow within circular culverts along with the variables used to design the energy dissipator.

Variables from the figure

D -- Diameter of original culvert
V_n -- Tailwater velocity
y_n -- Tailwater depth
L -- Length from beginning of one roughness element to the beginning of the next roughness element.
h -- Height of roughness element
h₁ -- length from top of roughness element to enlarged culvert ceiling
h₂ -- height of splash shield on enlarged culvert ceiling.
h₃ -- rise of enlarged culvert.

Variables from the figure

D -- Diameter of original culvert
D₁ -- Diameter of enlarged culvert
D_i -- Diameter of roughened section
h -- Height of roughness element
L -- Length from beginning of one roughness element to the beginning of the next roughness element.

Variables from the figure

v • e HY-8
Introduction:	Getting Started • Layout • Vena Contracta • Building a Project • Locate Project • Culvert Crossing Data • Run Analysis • Report Generation
Crossing and Culvert Data:	Crossings • Discharge Data • Roadway Data • Tailwater Data • Irregular Channel • Culvert Data • Site Data • Culvert Invert Data • Embankment Toe Data
Analysis	Project Units • Roadway Overtopping • Inlet Control Computations • Outlet Control Computations • Tables and Plots
Energy Dissipation	Scour Hole Geometry • Increased Resistance • Tumbling Flow • USBR Type IX Baffled Apron • Drop Structures • Stilling Basins • Streambed Level Structures
Methods	Aquatic Organism Passage • Low Flow Hydraulics
Troubleshooting	Differences from DOS HY-8 • Limitations • HY-8 User Manual