|
|
| Line 1: |
Line 1: |
| Redundant and overlapping data may exist in a scattered XYZ data sets. WMS offers the ability to filter the data and remove unnecessary data points in relatively flat areas in the '''Filter''' command from the '''TIN''' menu. The user specifies an angle. Each data point is checked to see if it is in a flat region by dotting the normals of the surrounding triangles.
| | #REDIRECT [[WMS:TIN Menu]] |
| | |
| [[Image:image270.gif]]
| |
| | |
| If the normals are all within the specified angle, the region is considered flat and the point is deleted.
| |
| | |
| This type of processing is very important when trying to use LIDAR data. Typical LIDAR collection results in resolutions of 1-3 meters so that good detail of flood plains and channel banks is achieved. However this leaves massive amounts of points in relatively flat areas where the increased resolution is not required (it would be like asking your surveyor to get points every 5 feet just so he doesn't miss anything, when hopefully he can be much smarter). The filtering eliminates the points where they are not needed and retains the important points. (The [[WMS:References|reference]] to Creighton Omer's paper is about a study using this technique on LIDAR data for hydraulic modeling that concludes a filter angle of 4-8 degrees can be used that will result in up to 85% data reduction without impacting hydraulic modeling results.)
| |
| | |
| | |
| ==Related Topics==
| |
| * [[WMS:References|References]]
| |
| * [[WMS:Vertices|Deleting Vertices]]
| |
| * [[WMS:Triangulation|Triangulating]]
| |
| | |
| | |
| {{WMSMain}}
| |
