HY8:Locate Project

From XMS Wiki
Revision as of 15:52, 15 September 2016 by Jcreer (talk | contribs)
Jump to navigationJump to search

Locate Crossing

The first step in building a project is to identify the location of the crossing. The project contains all of the crossings while the crossings are the locations at which the culverts are placed. If desired (not required), the map viewer WMSIcon GIS Module.png tool may be used to locate the crossing by entering (latitude,longitude) coordinates or the address of the crossing as shown in the figure below.

Virtual Earth Map Locator


v • e
HY-8
Introduction:Getting Started   •   Layout   •   Vena Contracta   •   Building a Project   •   Locate Project   •   Culvert Crossing Data   •   Run Analysis   •   Report Generation
Crossing and Culvert Data:Crossings   •   Discharge Data   •   Roadway Data   •   Tailwater Data   •   Irregular Channel   •   Culvert Data   •   Site Data   •   Culvert Invert Data   •   Embankment Toe Data
AnalysisProject Units   •   Roadway Overtopping   •   Inlet Control Computations   •   Outlet Control Computations   •   Tables and Plots
Energy DissipationScour Hole Geometry   •   Increased Resistance   •   Tumbling Flow   •   USBR Type IX Baffled Apron   •   Drop Structures   •   Stilling Basins   •   Streambed Level Structures
MethodsAquatic Organism Passage   •   Low Flow Hydraulics
TroubleshootingDifferences from DOS HY-8   •   Limitations   •   HY-8 User Manual
Retrieved from "https://www.xmswiki.com/index.php?title=HY8:Locate_Project&oldid=111896"