HY8:LOWFLOW Method

From XMS Wiki
Revision as of 16:15, 1 December 2016 by Jcreer (talk | contribs)
Jump to navigationJump to search

Low Flow Hydraulics Method

The HY-8 Low Flow Hydraulics method is based on the TFHRC report: Fish Passage in Large Culverts With Low Flow. The method divides half of the culvert span into slices. The velocity and depth of that slice are computed, then compared to a threshold. If the slice has a velocity lower than the threshold and a depth greater than the threshold, the slice is determined to pass the requirements. For more information on this method, please see the TFHRC report listed above.

CulvertCrossSectionSlices.jpg

The Low Flow Hydraulics RunLowFlowHydraulicsIcon.png calculator may be used any time that there is a requirement on depth or velocity through a culvert. This method is commonly used to determine fish passage where the threshold depth and velocity relate to the swimming ability of a targeted fish.

Low Flow Hydraulics Dialog

The Low Flow Hydraulics dialog have the following options:



v • e
HY-8
Introduction:Getting Started   •   Layout   •   Vena Contracta   •   Building a Project   •   Locate Project   •   Culvert Crossing Data   •   Run Analysis   •   Report Generation
Crossing and Culvert Data:Crossings   •   Discharge Data   •   Roadway Data   •   Tailwater Data   •   Irregular Channel   •   Culvert Data   •   Site Data   •   Culvert Invert Data   •   Embankment Toe Data
AnalysisProject Units   •   Roadway Overtopping   •   Inlet Control Computations   •   Outlet Control Computations   •   Tables and Plots
Energy DissipationScour Hole Geometry   •   Increased Resistance   •   Tumbling Flow   •   USBR Type IX Baffled Apron   •   Drop Structures   •   Stilling Basins   •   Streambed Level Structures
MethodsAquatic Organism Passage   •   Low Flow Hydraulics
TroubleshootingDifferences from DOS HY-8   •   Limitations   •   HY-8 User Manual
Retrieved from "https://www.xmswiki.com/index.php?title=HY8:LOWFLOW_Method&oldid=115765"