HY8:Locate Project

Locate Crossing

The first step in building a project is to identify the location of the crossing. The project contains all of the crossings while the crossings are the locations at which the culverts are placed. If desired (not required), the map viewer tool may be used to locate the crossing by entering (latitude,longitude) coordinates or the address of the crossing as shown in the figure below.

File:HY8image29.jpg

Related Topics

HY-8 Main Page

Introduction

• Introduction
• HY-8 Getting Started
• Differences from DOS HY-8
• Limitations

Building a Project

• Building a Project
• Locate Project
• Culvert Crossing Data
• Run Analysis
• Report Generation