AHGW:Troubleshooting 3D Bore Lines

From XMS Wiki
Revision as of 23:41, 9 September 2019 by Move page script (talk | contribs) (Move page script moved page AHGW:Troubleshooting 3D Bore Lines to Test:Troubleshooting 3D Bore Lines without leaving a redirect)
Jump to navigationJump to search

In may cases, this problem is related to the dimensions of the feature classes. In many cases, feature datasets and feature classes are created with a limited Z domain with a value of set 0 as the minimum Z value, so features with elevations below 0 can not be written to the feature classes in this feature dataset.

Here are the steps for redefining the Z domain:

  • Create a new geodatabase
  • Create a new feature dataset
  • make sure your feature dataset has the appropriate units (feet, meter) so that x, y, and z units are the same and match the vertical data in the BoreholeLog table.
  • When you create the new feature dataset and get to the step defining the vertical coordinate system you will need to select one appropriate for your area.
  • In the next step – uncheck the accept default resolution and domain extent toggle.

AHGW New Feature Dataset dialog.png

  • In the next step set a minimum value for the Z domain that will include your data range.

AHGW New Feature Dataset dialog 2.png

  • Select Finish to create the feature dataset.
  • Load the data (wells, boreline) you have into the new feature dataset.
  • Run the Create BoreLines tool with the data in the new feature dataset.