HY8:Channel Shape: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
Line 8: Line 8:
   
   
[[Image:HY8Tailwater.jpg|600 px]]
[[Image:HY8Tailwater.jpg|600 px]]
   
   
[[Image:HY8Channel_Shape.jpg|300 px]]
[[Image:HY8Channel_Shape.jpg|300 px]]

Revision as of 15:35, 14 June 2016

There are three available channel shapes to define the downstream tailwater channel: rectangular, trapezoidal, and triangular. When selecting a channel shape the input window adjusts to display only those parameters required for the defined shape. When defining a channel shape, the following channel properties are required for analysis:

  • Bottom Width — Width of channel at downstream section, shown in drawing below.
  • Side Slope (H:V) (_:1) — This item applies only for trapezoidal and triangular channels. The user defines the ratio of Horizontal/Vertical by entering the number of horizontal units for one unit of vertical change.
  • Channel Slope — Slope of channel in m/m or ft/ft. If a zero slope is entered, an error message appears upon exiting the input data window. The user must enter a slope greater than zero before the crossing may be analyzed.
  • Manning's n — User defined MANNING'S roughness coefficient for the channel.
  • Channel Invert Elevation — User must enter elevation. Program will show actual barrel #1 outlet invert elevation.


HY8Tailwater.jpg


HY8Channel Shape.jpg