HY8:Channel Shape

From XMS Wiki
Revision as of 14:52, 1 July 2011 by Cmsmemoe (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

There are three available channel shapes to define the downstream tailwater channel: rectangular, trapezoidal, and triangular. When selecting a channel shape the input window adjusts to display only those parameters required for the defined shape. When defining a channel shape, the following channel properties are required for analysis:

Bottom Width -- Width of channel at downstream section, shown in drawing below.

Side Slope (H:V) (_:1) -- This item applies only for trapezoidal and triangular channels. The user defines the ratio of Horizontal/Vertical by entering the number of horizontal units for one unit of vertical change.

Channel Slope -- Slope of channel in m/m or ft/ft. If a zero slope is entered, an error message appears upon exiting the input data window. The user must enter a slope greater than zero before the crossing may be analyzed.

Manning's 'n' -- User defined MANNING'S roughness coefficient for the channel.

Channel Invert Elevation -- User must enter elevation. Program will show actual barrel #1 outlet invert elevation


HY8Tailwater.jpg


HY8Channel Shape.jpg


Related Topics

Introduction

Crossings Data

Roadway Data

Tailwater Data

Irregular Channel