HY8:Stilling Basins

The four types of Stilling Basins External Energy Dissipators available in the program:

• USBR Type III Stilling Basin
• USBR Type IV Stilling Basin
• St. Anthony Falls (SAF) Stilling Basin

The maximum width of an efficient 'USBR' type stilling basin is limited by the width that a jet of water would flare naturally on the basin foreslope. The user is given the maximum flare value and is prompted to enter a basin width smaller than this value. If a 'SAF' basin is used, the basin width is set equal to the culvert width and the user is prompted to choose either a rectangular or flared basin depending on site conditions. Stilling Basins resemble the following illustration.

Variables from the figure

• W0 -- width of the channel
• WB -- Width of the basin
• y0 -- Culvert outlet depth
• Y1 -- Depth entering the basin
• Y2 -- Conjugate depth
• S0 -- Slope of the channel
• ST -- Slope of the transition
• SS -- Slope leaving the basin
• Z0 -- ground elevation at the culvert outlet
• Z1 -- ground elevation at the basin entrance
• Z2 -- ground elevation at the basin exit
• Z3 -- Elevation of basin at basin exit (sill)
• LT -- Length of transition from culvert outlet to basin
• L -- Total basin length
• LB -- Length of the bottom of the basin
• LS -- Length of the basin from the bottom of the basin to the basin exit (sill)
• Tw -- Tailwater depth leaving the basin

Warning for Stilling Basin Width

Since the maximum basin width is a function of basin depth, the maximum width may decrease as the program increases the basin depth while converging on a solution. Therefore the maximum basin width may fall below the user's first choice for basin width. In this case, the user will be prompted for a new basin width.