HY8:Stilling Basins

From XMS Wiki
Revision as of 21:21, 16 December 2011 by Cmsmemoe (talk | contribs)
Jump to navigationJump to search

The four types of Stilling Basins External Energy Dissipators available in the program:


The maximum width of an efficient 'USBR' type stilling basin is limited by the width that a jet of water would flare naturally on the basin foreslope. The user is given the maximum flare value and is prompted to enter a basin width smaller than this value. If a 'SAF' basin is used, the basin width is set equal to the culvert width and the user is prompted to choose either a rectangular or flared basin depending on site conditions. Stilling Basins resemble the following illustration.


HY8image7.jpg


Variables from the figure

  • W0 -- width of the channel
  • WB -- Width of the basin
  • y0 -- Culvert outlet depth
  • Y1 -- Depth entering the basin
  • Y2 -- Conjugate depth
  • S0 -- Slope of the channel
  • ST -- Slope of the transition
  • SS -- Slope leaving the basin
  • Z0 -- ground elevation at the culvert outlet
  • Z1 -- ground elevation at the basin entrance
  • Z2 -- ground elevation at the basin exit
  • Z3 -- Elevation of basin at basin exit (sill)
  • LT -- Length of transition from culvert outlet to basin
  • L -- Total basin length
  • LB -- Length of the bottom of the basin
  • LS -- Length of the basin from the bottom of the basin to the basin exit (sill)
  • Tw -- Tailwater depth leaving the basin


Warning for Stilling Basin Width

Since the maximum basin width is a function of basin depth, the maximum width may decrease as the program increases the basin depth while converging on a solution. Therefore the maximum basin width may fall below the user's first choice for basin width. In this case, the user will be prompted for a new basin width.