SMS:Breaklines Workflow: Difference between revisions

Revision as of 21:16, 19 August 2015

To create breaklines, use the following steps:

1. Import breaklines.
Breaklines can be imported as a scatter set using the File Import Wizard.

2. Force breaklines in a mesh.
Use the Force Breaklines command in the Nodestrings menu. Set breakline options in the Nodestring Options dialog.

3. Force breaklines in a scatter set.
Use the Force Breaklines command in the Breaklines menu. Set breakline options in the Scatter Breakline Options dialog.

1. Create nodestrings/breaklines.
Select the Create Breakline tool. Click along points of a common elevation, such as at a bank toe or levee crest, to connect these points in the surface. Use the Backspace key to back up if an erroneous selection is made. Double-click or press Enter key to complete the breakline.

2. Import breaklines.
Breaklines can be imported as a scatter set using the File Import Wizard.

3. Force breaklines in a mesh.
Use the Force Breaklines command in the Nodestrings menu. Set breakline options in the Nodestring Options dialog.

4. Force breaklines in a scatter set.
Use the Force Breaklines command in the Breaklines menu. Set breakline options in the Scatter Breakline Options dialog.

@@ Line 23: / Line 23: @@
 :#Use the '''Force Breaklines''' command in the [[SMS:Scatter Breaklines Menu|''Breaklines'']] menu.
 :#Set breakline options in the [[SMS:Scatter Breakline Options|''Scatter Breakline Options'']] dialog.
 |}
+{{SMS Breaklines Workflow}}

v • e SMS – Surface-water Modeling System
Modules:	1D Grid • Cartesian Grid • Curvilinear Grid • GIS • Map • Mesh • Particle • Quadtree • Raster • Scatter • UGrid
General Models:	3D Structure • FVCOM • Generic • PTM
Coastal Models:	ADCIRC • BOUSS-2D • CGWAVE • CMS-Flow • CMS-Wave • GenCade • STWAVE • WAM
Riverine/Estuarine Models:	AdH • HEC-RAS • HYDRO AS-2D • RMA2 • RMA4 • SRH-2D • TUFLOW • TUFLOW FV
Aquaveo • SMS Tutorials • SMS Workflows