SMS:SRH-2D Boundary Conditions Workflow: Difference between revisions

Revision as of 18:27, 4 August 2015

Post-processing for an SRH-2D model in SMS is done using the following steps:

1. SRH-2D project setup.
Load a completed SRH-2D project. Start, build, and run an SRH-2D project. See also: SRH Project Workflow

2. Use hydrograph as inflow boundary conditions.
Define inflow hydrograph. Create monitoring points. Update model control. Run SRH-2D.

3. Use rating curve on the downstream boundary.
Define rating curve. Update model control. Run SRH-2D.

4. Use variable WSE on the downstream boundary.
Define variable WSE curve. Update model control. Run SRH-2D.

@@ Line 15: / Line 15: @@
 |
 #Define inflow hydrograph.
-#Create monitoring points.
+#Create [[SMS:SRH Coverages#Monitor Points Coverage|monitoring points]].
 # Update model control.
 # Run SRH-2D.

v • e SMS – Surface-water Modeling System
Modules:	1D Grid • Cartesian Grid • Curvilinear Grid • GIS • Map • Mesh • Particle • Quadtree • Raster • Scatter • UGrid
General Models:	3D Structure • FVCOM • Generic • PTM
Coastal Models:	ADCIRC • BOUSS-2D • CGWAVE • CMS-Flow • CMS-Wave • GenCade • STWAVE • WAM
Riverine/Estuarine Models:	AdH • HEC-RAS • HYDRO AS-2D • RMA2 • RMA4 • SRH-2D • TUFLOW • TUFLOW FV
Aquaveo • SMS Tutorials • SMS Workflows