SMS:SRH-2D Weir Workflow

To build an SRH-2D model using a weir, use the following steps:

1. SRH-2D project setup.

1. Create a new SRH-2D simulation. After creating the components of a simulation, create a new SRH-2D simulation. Right-click in the Project Explorer and select the New Simulations | SRH-2D command. 2. Add SRH-2D simulation components. To link components to the simulation, do one of the following. Right-click on the component and select the simulation name from the Apply To submenu. In the Project Explorer, click and drag items under the simulation object. 3. Set SRH-2D model parameters. Right-click on the simulation and select the Model Control command. Set the model parameters in the SRH-2D Model Control dialog. 4. Run the SRH-2D simulation. Right-click on the SRH-2D simulation and select Save Project, Simulation and Run to run the simulation. Use the Simulation Run Queue to track the model run.

2. Create pressure flow boundary conditions.
The pressure flow boundary conditions must be defined before running the simulation. To do this: Create a boundary conditions coverage. Create boundary condition arcs for the pressure flow. Assign boundary condition attributes to the pressure flow arcs.

3. Specify the simulation parameters.
The the simulation parameters must be defined before running SRH-2D. To do this: Create new simulation. Add components to simulation. Set up the simulation Model Control parameters.

4. Run the SRH-2D simulation.
Save the project. Check the model. Simulation execution. Troubleshooting.

5. Review results.
Results for the pressure flow can be visualized by doing the following: Create observation arcs. Run the Plot Wizard.