Projection Dialogs

From XMS Wiki
Jump to navigationJump to search

There are two main projection dialogs used in SMS, GMS< and WMS: The Display Projection dialog, and the Object Projection dialog. From each of these, the Select Projection dialog can be accessed. More detailed information about each projection and the information in these dialogs can be found in the Projections article.

Display Projection Dialog

File:DisplayProjection.jpg
Example of the Display Projection dialog.

The Display Projection dialog contains settings which are applied to the project as a whole.

Horizontal section

The Horizontal section of the dialog has two options available via radio buttons:

  • No projection - This option doesn't set a projection, and only allows adjusting the horizontal Units used in the project. The available units include:
    • "U. S. Survey Feet". Equal to 12003937 meters, approximately 0.3048006096 meters.
    • "International Feet". Equal to 0.3048 meters.
    • "Meters". Equal to the distance traveled by light in vacuum within 1299792458 of a second.
    • "Inches". Equal to 139.37 of a meter.
    • "Centimeters". Equal to 1100 of a meter.
  • Global projection - Clicking on the Set Projection button allows more specific projections to be set. These are listed below in the Select Projection Dialog section.

Vertical section

The Vertical section has two drop-down boxes:

  • Projection, giving the following options:
  • Units, giving the following options:
    • "U. S. Survey Feet"
    • "International Feet"
    • "Meters"
    • "Inches"
    • "Centimeters"

Object Projection Dialog

The Object Projection dialog is the same as the Display Projection dialog, but only applies to one specific object (e.g., a coverage or a mesh). It can be accessed by selecting the object in the Project Explorer, then right-clicking on it and selecting Projection... from the menu.

Select Projection Dialog

The Select Projection dialog.

The Select Projection dialog is accessed through the Set Projection... button in either the Display Projection dialog or the Object Projection dialog. It allows setting global projections for the project or for a specific object. It contains a single Projection tab with several options and sections.

Projection

The Projection drop-down contains the following options:

Zone

Datum

Planar Units

Parameters