SMS:RMA2 Spindown: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
Line 30: Line 30:


[[Category:RMA2|Spindown]]
[[Category:RMA2|Spindown]]
[[Category:SMS Dialogs|R]]
[[Category:RMA2 Dialogs]]
[[Category:Steering|R]]
[[Category:Steering|R]]
{{stub}}
{{stub}}

Revision as of 16:00, 24 November 2015

File:SMS Steering Module RMA2 Spindown.jpg
SMS Steering Module – RMA2 Spindown dialog

For cold start simulations, the initial velocities are zero and the water surface elevation is constant. This is often referred to as the "bathtub condition." Often RMA2 will not directly converge using these initial conditions.

Incremental Loading Strategy

The flow equations are nonlinear and thus require an iterative solution, starting from some initial guessed value. Convergence of the iterative solution is not guaranteed. Since the desired boundary conditions may be vastly different from a cold start condition, it may be impossible to get convergence starting from this bathtub type condition. However, a solution can be obtained using a series of “Runs” that generate solutions progressively closer to the desired answer. Intermediate boundary conditions that are closer to the final desired boundary conditions are specified to generate a set of flow conditions. These conditions do not represent the final desired flow conditions, but are closer to the final desired flow conditions than the original cold start, and can be used as initial conditions for a subsequent run. Starting the model from a previous solution is called “Hot Starting”. In the incremental loading strategy, “loads” consisting of applied flow rates and water surface elevations along the boundary increment from a cold start condition to the final condition. By choosing a suitably small increment in the boundary conditions, convergence can be attained.

RMA2 Spindown refers to the process of using the Steering Module to automate the process of incremental loading. The Steering Module can vary the following:

  • Boundary Conditions
  • Water surface elevation
  • Flow rate
  • Model Parameters
  • Eddy viscosity
  • Finite Element Network
  • Geometry (nodal elevations)

This replaces the use of "REV" cards in RMA2.

Related Topics