SMS:SRH-2D Weir Workflow: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
No edit summary
Line 47: Line 47:
:# Load solution files.
:# Load solution files.
:# Organize and view solution files in SMS.
:# Organize and view solution files in SMS.
|}
|}



Revision as of 15:58, 14 August 2015

To build an SRH-2D model using a weir, use the following steps:

2. Create weir boundary conditions.
The pressure flow boundary conditions must be defined before running the simulation. To do this:
  1. Create a boundary conditions coverage.
  2. Create boundary condition arcs for the weir.
  3. Assign boundary condition attributes to the weir arcs.
  4. Modify the materials properties.
3. Specify the simulation parameters.
The the simulation parameters must be defined before running SRH-2D. To do this:
  1. Create new simulation.
  2. Add components to simulation.
  3. Set up the simulation Model Control parameters.
4. Run the SRH-2D simulation.
  1. Save the project.
  2. Check the model.
  3. Simulation execution.
  4. Troubleshooting.
5. Review results.

Results for the weir simulation can be viewed by doing the following:

  1. Load solution files.
  2. Organize and view solution files in SMS.