SMS:SRH-2D Monitor Points Workflow: Difference between revisions

From XMS Wiki
Jump to navigationJump to search
No edit summary
Line 13: Line 13:
|-
|-
|width="800"|
|width="800"|
:The pressure flow boundary conditions must be defined before running the simulation. To do this:
:The monitor points must be defined before running the simulation. To do this:
:#Create a [[SMS:SRH Coverages#Monitor Points Coverage|monitor points]] coverage.
:#Create a [[SMS:SRH Coverages#Monitor Points Coverage|monitor points]] coverage.
:#Use the Create Feature Points tool to create monitor points in the coverage.
:#Use the Create Feature Points tool to create monitor points in the coverage.
Line 25: Line 25:
:# Create new [[SMS:Simulations|simulation]].
:# Create new [[SMS:Simulations|simulation]].
:# Add [[SMS:SRH Simulation|components to simulation]].
:# Add [[SMS:SRH Simulation|components to simulation]].
:# Add the monitor points coverage to the simulation.
:# Add the [[SMS:SRH Coverages#Monitor Points Coverage|monitor points coverage]] to the simulation.
:# Set up the simulation [[SMS:SRH Model Control|''Model Control'']] parameters.
:# Set up the simulation [[SMS:SRH Model Control|''Model Control'']] parameters.
|}
|}
Line 43: Line 43:
|-
|-
|width="800"|
|width="800"|
Results for the monitoring points can be viewed by doing the following:
Results for the monitor points can be viewed by doing the following:
:# Load solution files.
:# Load solution files.
:# Organize and view solution files in SMS.
:# Organize and view solution files in SMS.

Revision as of 17:34, 18 August 2015

To use SRH-2D monitoring points, follow the steps below:

2. Create monitor points.
The monitor points must be defined before running the simulation. To do this:
  1. Create a monitor points coverage.
  2. Use the Create Feature Points tool to create monitor points in the coverage.
3. Add the monitor points to the simulation.
The monitoring points must be added ti the simulation before running SRH-2D. To do this:
  1. Create new simulation.
  2. Add components to simulation.
  3. Add the monitor points coverage to the simulation.
  4. Set up the simulation Model Control parameters.
4. Run the SRH-2D simulation.
  1. Save the project.
  2. Check the model.
  3. Simulation execution.
  4. Troubleshooting.
5. Review results.

Results for the monitor points can be viewed by doing the following:

  1. Load solution files.
  2. Organize and view solution files in SMS.