SMS:SRH-2D Culvert Workflow

To build an SRH-2D model using a culvert, use the following steps:

[show]1. SRH-2D project setup.

Start with an SRH-2D project that ready to have a structure added. Load an SRH-2D project. Start and build componets for an SRH-2D simulation. Before creating a structure, the SRH-2D project should have already have the following: Data for project has been imported. Elevation data has been reviewed and edited including that all projections are correct. Model limits defined. Materials have been defined. See also: SRH Project Workflow

[show]2. Create culvert boundary conditions.
Create boundary condition arcs for the culvert. Specify the HY-8 culvert definition file. Assign the boundary condition attributes and define the culvert in HY-8. Modify the materials coverage.

[show]3. Specify the initial conditions of the stream.

[show]4. SRH-2D simulation setup.
Create new simulation. Add components to simulation. Set up Model Control parameters. Check the model. Simulation execution. Troubleshooting.

[show]5. Review results.
Open _XMDF file. Results layers. Observation lines. Summary table. Run the Plot Wizard. Data calculator.