GMS:FEMWATER Commands

The FEMWATER menu becomes available after a FEMWATER simulation has been created. Below the commands in this menu:

Menu Command	Description
New Simulation...	Starts a new FEMWATER simulation. This command will delete any existing FEMWATER data running in GMS.
Delete Simulation...	Removes the selected FEMWATER simulation.
Check Simulation...	Starts the Model Checker dialog..
Run FEMWATER...
Read Solution...	Opens a FEWATER solution file.
Geometry File...
Titles...	Brings up the FEMWATER Geometry and Model Title Cards dialog. See Titles for more information.
Run Options...	Opens the FEMWATER Run Options dialog.
Initial Conditions...	Opens the FEMWATER Initial Conditions dialog. See FEMWATER Initial Conditions for more information.
Iteration Parameters...	Brings up the Iteration Parameters dialog. See Iteration Parameters for more information.
Particle Tracking...	See Particle Tracking Parameters for more information.
Time Control...	See Time Control Parameters for more information.
Output Control...	See Output Control for more information.
Fluid Properties...	Opens the Fluid Properties dialog. See Fluid Properties for more information.
BC Display Options...
Variable BC Options...
Assign Node/Face BC...	Either assigns a new boundary condition or edits an existing boundary condition to a selected set of boundary nodes or boundary element faces. See Assign Node/Face BC for more information.
Point Source/Sink BC...	Assigns a flow rate to a node. See Point Source/Sink BC (Wells) for more information.
Delete BC

Related Topics

• FEMWATER