SMS:FESWMS Menu

The following menu commands are available in the FESWMS Menu:

• Assign BC (Boundary Condition) – Opens either the FESWMS Nodestring Boundary Conditions dialog or the FESWMS Nodal Boundary Conditions dialog. A node or nodestring must be selected for this command to be available.
• Local Parameters – Brings up the FESWMS Local Parameters dialog. Requires that a node be selected.
• Initial Conditions – Brings up the Initial Conditions Data dialog.
• Weir – Opens the FESWMS Weir dialog. Requires a selected nodestring be active.
• Culvert – Brings up the FESWMS Culvert dialog. Requires that the inlet and outlet nodes are currently selected.
• Drop Inlet – Brings up the Drop Inlet Definition dialog. Requires that a node is currently selected.
• Channel Link – Brings ups the FESWMS Channel Link dialog.
• Gate – Opens the FESWMS Gate dialog.
• Pier – Brings ups the FESWMS Pier Definition dialog.
• FLUX String – Option to set currently selected nodestring to Total Flow string.
• Material Properties – Opens the FESWMS Material Properties dialog. This dialog is different than the general Material Properties dialog in SMS.
• Model Check – Runs the model check. If there are errors, then the Model Check dialog will appear.
• Model Control – Brings up the FESWMS Model Control dialog.
• Run FST2DH – Starts the FST2DH model wrapper.

Local Parameters Dialog

FESWMS Local Parameters dialog

Initial Conditions Dialog

Initial Conditions Data dialog

Related Topics

• FESWMS